University of Notre Dame
Browse

Wear of structural oxide ceramics produced through additive manufacturing

journal contribution
posted on 2019-10-16, 00:00 authored by Andrew Rosenberger, Bernice Aboud Gatrell, Colton Steiner, Haibo Qu, J. Schiltz, Paul McGinn, Steve Schmid, Todd Render
Ceramics have exceptional tribological performance in high wear applications, but susceptibility to brittle fracture requires expensive postprocessing, including hot isostatic pressing and polishing. Consequently, additive manufacturing (AM) represents a collection of potentially costsaving approaches for ceramic production. AM technologies have been demonstrated for oxide ceramics, but the performance of self-mated AM materials remains unknown and underscores a critical knowledge gap. Alumina and zirconia pins produced with photo-polymerization, binderjetting, or material-jetting were obtained. For each fabrication method, the average wear coefficient was determined using pin-on-disk testing. Conventionally pressed and sintered ceramics were applied as counterface surfaces and controls. The manufacturing approach did not demonstrate differences in wear coefficient for zirconia. However, photopolymerized alumina was shown to outperform material-matched binder-jetted and conventional pin-disk tribopairs. Starting surface roughness and bulk density were found to correlate volumetric wear. Characterization of the AM ceramics revealed that photo-polymerization and material-jetting were capable of dense and refined microstructures. Evaluations indicate that ceramics produced with photo-polymerization and certain powder-bed AM approaches meet and exceed conventional ceramics, supporting the expansion of AM ceramic applications.

History

Date Modified

2019-10-16

Language

  • English

Alternate Identifier

23519789

Publisher

Elsevier

Usage metrics

    Integrated Imaging Facility

    Categories

    No categories selected

    Keywords

    Exports

    RefWorks
    BibTeX
    Ref. manager
    Endnote
    DataCite
    NLM
    DC